With this in mind, when I went to the Quilt Show, here in Melbourne recently, I went looking for a binding tool I'd seen on Pinterest. I found the tool, but the helpful assistant said she used a different one which she preferred and would I like that one instead. "OK" says I, and I bought the Westalee "Bound to Fit" tool (it's designed and made in Oz)
Well, let me tell you - it's BRILLIANT!!
You can cut your binding strips with a 45 degree angle which are easily aligned and then, the ease at which you join them at the end is just fabulous, sweetie darling. Let me show you......
|I cut my binding at 2.25" wide - and obviously usually longer than this piece - it's just so you can see|
Then you cut it, including the little straight bit on the bottom right there - this is what helps you join the strips together with more accuracy
Then, you turn your strip around (or turn the tool around - but not upside down) to create angles all going the same way - they'll be parallelogram shaped for those geometrically inclined
|obviously way smaller than required!|
Then you sew - and I like to press the seam open to reduce more bulk, but I know some people prefer to press to the side
|seam pressed open|
|binding folded in half lengthwise and pressed ready to attach to the quilt|
Look at that - perfick! and just wait til you see how easy it is to join the binding strips together once it's on the quilt..
So now I have a real quilt and I did all of the above to join my binding strips. I left a 'tail' of about 8 inches before I started sewing the binding on as normal, then once round to the end, I left another 'tail' to give me enough room to maneuver..
Next you need to make a mark where the 2 'tails' have to join - simply fold the binding back on itself, opposite ways, and finger press (or iron) to create a crease - make sure your 2 folded 'tails' are touching each other..
Then, whip out your tool and align the white 'to fold' line with the crease - I've chalked the crease line in so you can see it better..then cut off the tail..
Next step is the other 'tail' - but remember to turn the tool around - and cut that tail off too..
Pin them right sides together and stitch..
Finger press the seam as before, refold the binding and stitch into place..
This is the quilt completed after I stitched down the binding (by machine and using my trusty Clover binding clips - love them) - this will be for sale at Red Hill Market.
Westalee have a very helpful video tutorial.
I hope to stock these wonderful tools for resale - let me know if you'd like one :)